For some parts of automatic knitting machine, such as spindle support and sliding seat, the accurate distance between the sliding seat and the braiding line of the lower spindle must be ensured after maintenance and disassembly or when the new parts are replaced. It is suggested to place a sliding frame and its upper spindle on the sliding turntable first, so that the braided yarn of the lower anchorage will not be caught or cut off by the sliding frame when leading from the swing rod to the knitting point.

The distance can be adjusted by changing one or more gears forward or backward of the gear carrier.

If the precise adjustment distance can not be achieved by moving a tooth, fine adjustment can be carried out according to the following steps: loosen the five fixed screws on the inner gear ring. Since the through-hole is elliptical, moving the inner gear ring can achieve fine adjustment of the sliding frame, and then tighten the screws after adjusting in place. The rest of the sliding frames are evenly placed on the sliding ring track. If the swing height of the braided wire is different after the new swing rod is installed, it should be adjusted until all the swing rods have the same stop point.